This is one of those things I really don't like doing. But, I just got to love it.
Enjoy!
Ironing clothes is one of
those tasks that has a tendency to be a bit terrifying, but worry not, it
just seems overly complicated. Here, we'll break it down into the
three simplest, most common cases: Shirts, pants, and skirts.
What you’ll need:
A clean iron (without rust or burnt starch, because that ruins
clothes!)
An ironing board
A bit of water, preferably in a spray bottle
Some light starch if you like to use it
Yes, an ironing board really is necessary. Ironing boards are
specially made to make the job easier, but more than that, they're wrapped in
special material that's not only flame retardant, but also breathable so that
steam is able to escape from underneath the item you're ironing.
Shirts
Ironing shirts is quicker and easier than you might think. It should only
take an average of three minutes to properly iron a shirt, and that's doing it
the right way.
It's best to start with the sleeves, since they'll be just fine hanging
off the sides of the ironing board while you finish the rest of the shirt.
Doing it the other way around, and leaving the sleeves for last, will end up
causing wrinkles in other parts of the shirt that you've already ironed.
Open the cuffs! This is something that many ironing newcomers get wrong
all the time, but it's not just easier to open the cuffs and lay them flat, but
it lets you do a better job ironing the whole sleeve, too.
When doing the collar of the shirt, make sure you open it up and lay it
flat. Just like the cuffs, people tend to think that this is opposite of what
they should do, since they're used to seeing the collar in the down position
at all times.
Afterwards, let the shirt hang for a few minutes to fully cool down.
Ironing heats the fabric to a very high relative temperature, and the
"flatness" actually sets in during the cool down phase, so wearing it
immediately could negate some of the hard work you just put into ironing it in
the first place.
Pants
There's a reason people say "press" instead of "iron"
for pants. Even though you'll still be using an iron, it's gentle pressure and
steam that are going to do the work, not so much the motion and heat of the
iron itself.
If you've lost your main crease (pressing lines), finding it again is
easy. Just lay the pants flat on the ironing board, and line up the seams of
the leg to match. The crease is as far from those seams as the fabric goes.
The crease should go all the way up the leg, stopping at about six inches
below the waist. If there are pleats, then the crease can go all the way to the
pleat. Always set the front crease first.
If you've pressed in a crease, the pants should hang by the waistband for
at least an hour or two to set. If you don't put creases in your pants, don't
worry about it! Just give them a few minutes to cool.
Skirts
For most skirts, it's as simple as starting at the top and working your
way down. An exception would be for skirts that flare out suddenly at the
bottom, with what are called "flounces." For flounced skirts, you'd
want to start at the bottom, and iron each flounce first, then work your way up
toward the waist. Basically, skirts are just plain easy—you just need to be
careful about the fabric.